Upgrading A Single Eme Module - 3Com 4007 Release Note

Upgrading a Single
EME Module
With only one EME module installed in a chassis, the module's software
should be installed in this order:
This is an overview procedure. Each step leads you to a set of specific
instructions elsewhere in this chapter. After you complete a set of
instructions, return to this procedure and go to the next step.
1 Install EMC boot software, version 2.1. For instructions, see "Installing
EMC Boot Software" later in this chapter. (Do not reinstall if it already
exists on your module.) After the module finishes resetting, go to the
next step.
2 Install EMC operational software, version 3.0.0. For instructions, see
"Installing EMC Operational Software" later in this chapter. (Do not
reinstall if it already exists on your module.) After the module finishes
resetting, go to the next step.
3 Install EME boot software, version 3.0.0. For instructions, see "Installing
EME Boot Software" later in this chapter. (Do not reinstall if it already
exists on your module.) After the module finishes resetting, go to the
next step.
4 Install EME operational software, version 3.0.5. For instructions, see
"Installing EME Operational Software" later in this chapter. After the
module finishes resetting, go to the next step.
5 Follow this final step ONLY if you have upgraded any piece of software on
your EME module from 2.x to 3.x.x:
a Flush the Address Resolution Protocol (ARP) table on the PC
management station from which you connected to the EME module.
b Flush the ARP table on the TFTP server from which you downloaded
software to the EME module.
c Ping the server or management station to verify that you are
connected properly.
The MAC addresses of the EME were changed in release 3.0.0. The
process of flushing the ARP tables on the management station and TFTP
server makes these devices relearn the new MAC addresses.
The upgrade process is complete.
Upgrading the EME Module to Release 3.0.5 105