Password Access; System And Module Naming; Web Management; Known Problems In Release - 3Com 4007 Release Note

30 C 3: R
HAPTER ELEASE

Password Access

System and Module
Naming

Web Management

Known Problems in
Release 3.0.5

Diagnostics

I F M M
SSUES OR ANAGEMENT
To gain access to the EME command interface, the system prompts
you for a username and password. The default username is
(lowercase), but there is no default password. The first time that you
log in, simply press Enter at the password prompt.
To define a password for your EME, use the
command. After you enter the password, the EME user interface
prompts you to reenter it to verify it.
When you create the system name through the Administration
Console command line interface, you can use spaces in the name and
no quotation marks are required. However, when you create a module
name that contains spaces, then you must use quotation marks
around the module name. 3Com recommends that you not use
spaces for the module name.
You need to click some security windows in the Web Management
interface twice for the browser to accept the information. (24806)
If you use Netscape as your browser, you must install the Help files on
an external server, not on a local PC. For instructions on how to install
and configure Help for the Netscape browser, see the
"Documentation Changes" chapter later in these release notes.
(29490)
This section describes the problems that are known to exist for an EME
that is operating with software Release 3.0.5.
The EME incorrectly displays the following message when you set the
servdiag loop count to 0 with the
command:
Test may take up to 2 minutes and 0 seconds
Do you wish to continue (y/n):
The servdiag test runs forever, as it is designed to do when you set the
loop count to 0 (not up to 2 minutes) . (30015)
ODULES
set servdiag 2.1 loop_cnt 0
admin
set login password