3Com 4007 Release Note page 25

The
set snmp trap
destinations, filters, and trap receive settings.
set snmp trap
destination
<community>
filter
link_state
enable
disable
topology_change
enable
disable
authentication
enable
disable
receive
enable
disable
command enables you to configure trap
Set the trap destination. The system
prompts for an IP address.
Enables or disables the generation of
link state traps.
Enables or disables the generation of
topology change traps.
Enables or disables the generation of
authentication traps.
As a trap receiver, the EME receives
traps from other SNMP devices,
including other CoreBuilder 9000
modules, that have the EME IP
address in their community table.
You can specify the network
management stations that receive
alerts from the EME. To do so, you
must create a new community table
entry for each network management
station.
Note that SNMP traps are
transmitted only through an in-band
IP routing interface.
Trap Filtering 25