Installing Eme Boot Software; Installing Eme Operational Software - 3Com 4007 Release Note

Installing EME Boot
Software
Installing EME
Operational Software
To upgrade a module's EME boot software to version 3.0.0, enter the
following commands and information:
When downloading to a Slave/Secondary module, use this command:
CB9000> download module <slot.subslot> boot_image <server
address> eme30000.bt
When downloading to a Master/Primary module, use this command:
CB9000> download eme boot_image <server address> eme30000.bt
Where
<slot.subslot>
IP address of the server where the software image resides.
The system indicates that downloading software will cause the module to
reset and asks if you want to continue. Enter
To upgrade a module's EME operational software to version 3.0.5, enter
the following commands and information:
When downloading to a Slave/Secondary module, use this command:
CB9000> download module <slot.subslot> oper_image <server
address> eme30005.op
When downloading to a Master/Primary module, use this command:
CB9000> download eme oper_image <server address> eme30005.op
Where
<slot.subslot>
IP address of the server where the software image resides.
The system indicates that downloading software will cause the module to
reset and asks if you want to continue. Enter
Upgrading the EME Module to Release 3.0.5
is either 8.2 or 9.2 and
is either 8.2 or 9.2 and
<server address>
(yes).
y
<server address>
(yes).
y
109
is the
is the