Ricon LASER AP1600 Operating Instructions Manual page 86

R CAUTION:
• When lifting the printer, use the
grips on both sides of the printer,
otherwise the printer might fall
and cause personal injury.
• When you move the printer, un-
plug the power cord from the wall
outlet to avoid a fire or an electric
shock.
• When you pull out the plug from
the socket, grip the plug to avoid
damaging the cord and causing
a fire or an electric shock.
Type 1 printer
Note
See the inside front cover of this
manual to confirm which printer
(Type 1 Printer or Type 2 Printer)
you have.
A
Turn the printer's power switch
off.
B
Pull out the plug from the socket.
Remove all the cables from the
printer.
Note
Do not touch the three white
pins on the right front of the
printer.
C
Slide the paper tray out until it
stops. After that, lift it slightly,
then slide it out of the printer.
D
Move the printer to the edge of a
stable table or desk.
Important
Do not put the printer on an un-
stable or tilted surface.
If the printer is equipped with
the optional tray unit, do not
move the printer and unit to-
gether as they are not securely
attached.
When lifting the printer, con-
firm that the optional tray unit
is not attached to the printer.
E
Slide the green lock lever to the
right (A A A A ), so that the paper feed
roller can be released (B B B B ).
1
2
F
Wipe the rubber part of the roller
with a soft damp cloth. After that,
wipe it with a dry cloth to remove
the water.
Cleaning the Printer
75
4