Table of Contents
Advertisement
D
Push the bottom plate down until
it locks into place.
E
Load envelopes into the envelope
feeder, with the print side up and
the flap on the right as shown in
the illustration.
Important
Confirm that the envelope flaps
are securely folded down, and
that there is no air inside the en-
velopes.
Note
Confirm that the top of the stack
is not higher than the limit mark
on the side guides.
Confirm that the envelopes fit
under the side guides.
Do not press down the stack of
envelopes with too much force.
Type 1 Printer: Loading Paper and Other Media
F
While pinching the side guides,
slide them along the edge of the
envelope stack.
G
While pinching the rear guide,
slide it along the edge of the enve-
lope stack.
TS3Y341E
H
While lifting the front of the tray,
place it into the printer. Then
slide it until it stops.
Important
If you slide the paper tray in
forcefully, the guide in the pa-
per tray might slip off.
I
Set the envelope size and feed di-
rection using the operation panel
as follows.
3
37
Advertisement
Table of Contents
