Ricon LASER AP1600 Operating Instructions Manual page 73

Troubleshooting
Possible Cause
Is the Data In indicator
blinking or lit after start-
ing the print job?
4
Note
If you cannot solve the problem by taking the preceding actions, contact your
sales or service representative.
62
Solutions
If not, the data is not being sent to the printer.
If the printer is connected to the computer using the in-
terface cable
Check if the printer port settings are correct. For a paral-
lel port connection, port LPT1 or LPT2 should be set.
• Windows 95/98
A
Click [Start] point to [Settings] and then click [Print-
ers].
B
Click to select the icon of the printer. Next, on the
[File] menu, click [Properties].
C
Click the [Details] tab.
D
Check the [Print to the following port] box to confirm
that the correct port is selected.
• Windows 3.1x
A
On [Control Panel], double-click the [Printers] icon.
B
Confirm that this printer is set as the default print-
er.
C
Click [Connect].
D
Check the [Ports] box to confirm that the correct
port is selected.
• Windows NT 4.0
A
Click [Start], point to [Settings] and then click [Print-
ers].
B
Click to select the icon of the printer. Next, on the
[File] menu, click [Properties].
C
Click the [Port] tab.
D
Check the [Print to the following port] box to confirm
that the correct port is selected.
Network Connection
Contact your network administrator.