Table of Contents
Advertisement
Preparing to replace the parts
Important
Be sure to follow the steps below
before replacing the parts.
A
Turn the printer's power switch
off.
B
Pull the plug out of the wall sock-
et.
C
Remove the interface cable from
the printer.
Replacing the friction pad
Replace the friction pad of the stand-
ard tray (tray 1). It is not necessary to
replace the friction pad of the option-
al paper tray(s).
A
Slide the tray until it stops. After
that, lift it slightly, then slide it
out of the printer.
Note
Do not touch the three white
pins on the right side of the
printer.
B
Remove paper from the paper
tray. Turn the tray upside down
and place it on a flat surface.
C
Release the two black catches,
that lock the friction pad, using a
sharp-pointed item such as a ball-
point pen.
D
Turn the paper tray to the original
position, and remove the friction
pad from the tray.
E
Insert the new friction pad in the
paper tray. When inserting, note
the following:
Replacing Parts
TS3Y090E
6
TS3M100E
TS3M110E
103
Advertisement
Table of Contents
