Ricon LASER AP1600 Operating Instructions Manual page 76

Status
The desired tray is not used
for the output.
The printed image is differ-
ent from the image in the
computer.
It takes too much time to
resume printing.
The image is printed in the
wrong orientation.
Part of the image cannot be
printed.
Network configurations you
have made do not become ef-
fective.
Note
If the problem cannot be solved, contact your sales or service representative.
Possible Causes, Descriptions, and Solutions
Check the paper size settings. The size selected with
the paper size dial might be different from the actual
paper size. Make the correct dial setting.
⇒ P.29 "Type 1 Printer: Loading Paper and Other Media"
⇒ P.39 "Type 2 Printer: Loading Paper and Other Media"
When using the bypass tray, set the paper size using
the operation panel.
⇒ P.31 "Type 1 Printer: Loading Paper in the Bypass Tray"
⇒ P.41 "Type 2 Printer: Loading Paper in the Bypass Tray"
When you are using a Windows operating system, the
printer driver settings override those set using the op-
eration panel. Set the desired output tray using the
printer driver. See the driver's online help file.
When you use some functions such as enlargement
and reduction, the layout of the image might be differ-
ent from those shown in the computer display.
The data is so large or complex that it takes time to
process it. If the Data In indicator is blinking, the data
processing is being done. Just wait until it resumes.
Energy Saver mode might be enabled. In Energy Saver
mode, it takes time for the printer to warm up.
Changing the paper feed direction may sometimes re-
duce the time to resume printing.
Set the correct orientation under the "PCL Menu" with
the operation panel. ⇒ P.91 "PCL Menu"
Confirm that the setting of orientation has been set in
the application you use.
A paper size which is smaller than those selected in the
application is used for printing. Load the correct size of
paper.
Turn the printer's power switch off and then on. The
configuration sheet of Network Interface Board will be
printed automatically. Check the configuration of Net-
work Interface Board with this sheet.
Other Printing Problems
4
65