Table of Contents
Advertisement
Appendix
Replacement parts
You should replace all the parts in-
cluded in the maintenance kit at the
same time. Be sure to replace them in
the following order:
3
1
6
A
Friction pad
B
Paper feed roller
C
Transfer roller
D
Fusing unit
Preparing to replace the parts
Important
Be sure to follow the steps below
before replacing the parts.
A
Turn the printer's power switch
off.
B
Pull the plug out of the wall sock-
et.
C
Remove the interface cable from
the printer.
Replacing the friction pad
Replace the friction pad of the stand-
ard tray (tray 1). It is not necessary to
replace the friction pad of the option-
al paper tray(s).
108
4
2
R CAUTION:
• The paper tray does not have a
stopper. When pulling it out, be
careful not to pull it strongly. If
you do, the tray might fall and
cause personal injury.
A
Slide the tray out of the printer.
B
TS4M071E
Remove paper from the paper
tray. Turn the tray upside down
and place it on a flat surface.
C
Release the two black catches that
lock the friction pad, using a
sharp-pointed item such as a ball-
point pen.
TS4M080E
TS4M090E
TS4M101E
Advertisement
Table of Contents
