Ricon LASER AP1600 Operating Instructions Manual page 67

Troubleshooting
Messages
Print Overrun
4
Remove Misfeed
Front Cover&Tray
Remove Misfeed
Open Front Cover
Reset Fusing Unit
Reset Tray(s)
Correctly
Resetting Jobs
56
Description
The data sent to the printer is
too complex.
There is a misfeed in the
printer.
There is a misfeed in the
printer.
The fusing unit is not set cor-
rectly.
The tray on the paper feed-
ing path is not set correctly
when the printer receives
the print job.
The printer is resetting the
print job.
Comments
Press {Enter q} to print the data
sent to the printer. If you do not
want to lose any of the trans-
ferred data, set "Page Protect" to
"On" by Printer Driver when you
use PCL6 or PCL5e before print-
ing the job. When you use the PS
printer driver, set "Page Protect"
to "On" from Menu on the opera-
tional panel.
If the print result is not enhanced
when you use the PS printer driv-
er and set "Page Protect" to
"On", you should increase the
memory capacity and set "Page
Protect" to "On".
If you can not clear this message,
simplify the print job.
Note
Be sure to return "Page Pro-
tect" to "Auto" after the print
job. With "Page Protect"
"On", the printer performance
might be decreased.
Remove the misfed paper.
⇒ P.66 "Removing Misfed Paper"
Remove the misfed paper.
⇒ P.66 "Removing Misfed Paper"
Set the fusing unit correctly.
⇒ P.69 "If you uninstall the fusing
unit accidentally"
Set the tray correctly. The printer
will restart printing automatical-
ly.
Wait for a while.