Table of Contents
Advertisement
Appendix
A The three triangular projec-
tions should be facing toward
the front of the tray as shown
in the illustration.
B Align the center projection of
the new friction pad to the
spring of the paper tray.
C Also, align the projections of
both sides of the friction pad to
the holes of the paper tray as
shown in the illustration.
3
6
F
Push the friction pad until it locks
securely.
Important
Confirm that the friction pad is
set correctly, gently push it a
few times. If the friction pad re-
bounds with the force of the
spring, the pad has been set cor-
rectly.
G
Leave the paper tray pulled out
and go to P.104 "Replacing the pa-
per feed rollers".
Replacing the paper feed rollers
R CAUTION:
• When lifting the printer, use the
inset grips on both sides of the
printer, otherwise the printer
might fall and cause personal in-
jury.
104
2
1
TS3M120E
A
Move the printer to the edge of a
sturdy and stable table or desk.
Important
Do not put the printer on an un-
stable or tilted surface.
Note
If the printer is equipped with
the optional paper feed unit, do
not move the printer and the
unit together as they are not se-
curely attached.
B
When looking inside where the
paper tray was installed, you can
see the paper feed roller. Slide the
green lock lever to the right (A A A A ),
so that the paper feed roller will
be released (B B B B ).
1
2
TS3M140E
Advertisement
Table of Contents
