Table of Contents
Advertisement
Types of Paper and Other Media
Plain paper
• If you print on paper heavier than 90 g/m
bypass tray can hold paper up to 162 g/m
• If you load paper heavier than 155 g/m
the printer to Thick Paper mode using the operation panel.
• If paper is curled or bent, correct it before loading.
OHP Transparencies
• Load only one OHP transparency at a time onto the bypass tray.
• When loading an OHP transparency onto the bypass tray, set the printer
to Thick Paper mode using the operation panel.
• Be careful not to touch the print side of the OHP transparencies, otherwise
the print side gets dirty or damaged, and results in poor print quality.
• When printing on an OHP transparency that has a print side, load it facing
down onto the bypass tray.
Translucent paper
• Load only a piece of translucent paper at a time onto the bypass tray.
• When printing on translucent paper that has a print side, load it facing
down onto the bypass tray.
Adhesive labels
• Load only one adhesive label at a time onto the bypass tray.
• Use adhesive labels in which the whole side can be printed on.
• Do not use adhesive labels having exposed glue.
• If the print side is coated, print quality might be reduced, as the toner
might not fuse well.
Envelopes
• When printing on envelopes, use the bypass tray or the optional envelope
feeder.
• Even when the optional envelope feeder is not installed, you can select the
sizes for the envelopes for Tray 2 using the operation panel. However, you
cannot load the envelopes until the optional envelop feeder is installed.
To use the envelope feeder, the installation of the optional paper unit is re-
quired. See "Type 1 Printer: Installing Envelope Feeder Type 2000" and "Type
2 Printer: Installing Envelope Feeder Type 1400" in the "Setup Guide".
Paper and Other Media Supported by this Printer
2
(24 lb), use the bypass tray. The
2
(42 lb) in weight.
2
(41 lb) onto the bypass tray, set
3
25
Advertisement
Table of Contents
