Armstops; Angle Sensor For Autotilt; Sealing Strip (Horizontal); Sealing Strip (Vertical) - Zepro ZHD 2500-130 Installation Instructions Manual

Installation
6.8

Armstops

Fit end stops between the lift arms and the rear
beam of the vehicle floor. The left and right end stops
must be reached at the same time, as high up the lift
arm as possible. Installation must take place against
the vehicle body.
m
WARNING!
It is not permitted to perform welding in the lift arm.
Installation must take place against the vehicle
body.
6.9

Angle sensor for autotilt

When installing the angle sensor on the lift arm, see
Image 36.
NOTE.
When installing on the left arm, the sensor's cable
input must be facing upwards.
When installing on the right arm, the sensor's cable
input must be facing downwards.
6.10

Sealing strip (horizontal)

The track is fitted using the self-tapping screws
provided.
1. Mark where to drill holes for the self-tapping
screws.
2. Drill holes (Ø 7.2 mm) for the screws.
3. Fit the horizontal stop strip (steel or aluminium).
4. Fit the rubber strip to the track.
6.11

Sealing strip (vertical)

1. Fit the tracks with contersunk screws, rivets or
by spot welding.
2. Fit the rubber strip to the track.
3. Secure the rubber strips by swag-
ing the tracks together at the bottom.
NOTE.
To fit an upper edge seal, create a 45° mitre
against the vertical strips.
26
Image 35. Fit end stops between the lift arms
and the rear beam of the vehicle floor
Left
Image 36. Installing the angle sensor
Image 37. Installing a sealing strip
ZHD 2500-130/150
Right
www.zepro.com