Table of Contents
Advertisement
Installation
5.9
Angle sensor for autotilt
Install the angle sensor on the platform if the tail lift is fitted with autotilt. The angle sensor is connected but
not secured to the tail lift when delivered.
1. When installing the angle sensor on the platform, use the rivets supplied.
2. Secure the sensor cable with cable ties.
IMPORTANT!
Route the cable between the platform and the lift arm tube such that it is well protected when the plat-
form touches the ground.
Leave enough slack to the first cable tie to avoid the risk of damage to the cable during lift operation.
www.zepro.com
Picture 38. Installing the angle sensor
ZS MK2
29
Advertisement
Table of Contents
