Changing The Nozzle Filter - Toro Multi Pro 41240 Operator's Manual

Figure 106
1. Filter head
2. Gasket (bowl)
3. Filter element
3. Rotate the drain cap counterclockwise and
remove it from the bowl of the pressure filter
(Figure 106).
Note:
Allow the bowl to drain completely.
4. Rotate the bowl counterclockwise and remove
the filter head (Figure
5. Remove the old pressure filter element
106).
Note:
Discard the old filter.
6. Check the gasket for the drain plug (located
inside the bowl) and the gasket for bowl (located
inside the filter head) for damage and wear
(Figure 106).
Note:
Replace any damaged or worn gaskets
for the plug, bowl, or both.
7. Install the new pressure filter element into the
filter head (Figure
Note:
Ensure that the filter element is firmly
seated into the filter head.
8. Install the bowl onto the filter head, and tighten
by hand (Figure 106).
9. Assemble the drain cap onto the fitting at the
bottom of the bowl, and tighten the cap by hand
(Figure 106).
4. Gasket (drain plug)
5. Drain cap
6. Bowl
106).
(Figure
106).

Changing the Nozzle Filter

Note:
Determine the appropriate nozzle filter mesh
size that you need for your job; refer to
Nozzle-Tip Filter (Optional) (page
1. Park the machine on a level surface, engage the
parking brake, shut off the sprayer pump, shut
off the engine, and remove the key.
2. Remove the nozzle from the spray turret
107).
g033582
1. Spray turret
2. Nozzle filter
3. Remove the old nozzle filter
Note:
Discard the old filter.
4. Install the new nozzle filter
Note:
Ensure that the filter is fully seated.
5. Install the nozzle onto the spray turret
107).
74
Selecting a
51).
Figure 107
3. Nozzle
(Figure 107).
(Figure 107).
(Figure
g209504
(Figure