Greasing The Section Hinges; Engine Maintenance; Engine Safety; Checking The Air-Intake Screen - Toro MultiPro 1750 Operator's Manual

Greasing the Section
Hinges
Service Interval: Every 100 hours
Important:
If the section hinge is washed with
water, clear all water and debris from the hinge
assembly and apply fresh grease.
Grease Type: No. 2 lithium grease
1. Wipe the grease fittings clean so that foreign
matter cannot be forced into the bearing or
bushing.
2. Pump grease into the bearing or bushing at
each fitting (Figure
Figure 38
1. Grease fitting
3. Wipe off excess grease.
4. Repeat the procedure for each section pivot.
38).

Engine Maintenance

Engine Safety

Shut off the engine before checking the oil or adding
oil to the crankcase.
Checking the Air-Intake
Screen
Service Interval: Before each use or daily—Check
Every 100 hours—Clean the engine-rotating
screen (more often in dusty, dirty conditions).
Check and clean as necessary the air-intake screen
on the front of the engine before each use or daily.

Servicing the Air Cleaner

Service Interval: Every 50 hours/Yearly (whichever
Every 200 hours/Yearly (whichever comes first)
(more often in dusty, dirty conditions).
Removing the Foam and Paper
Elements
1. Set the parking brake, stop the pump, shut off
the engine, and remove the ignition key.
g002014
2. Release the latch on the back of the seat and lift
the seat forward.
3. Clean around the air cleaner to prevent dirt from
getting into the engine and causing damage
(Figure 39).
46
the engine-rotating screen.
comes first) (more often in dusty,
dirty conditions).