System Menu; Getting To The System Menu; Demo; Restore Defaults - Hardi Presidio 2700 Service Manual

6 - Deutz Display

System Menu

Getting to the System Menu

The "System Menu" is reached by pressing and holding key #5 for at least 3 seconds, when the Deutz Display is in its normal
operating mode.
The top-level configuration menu will be displayed on the LCD, as shown below.

DEMO

Allows the Deutz Display to run in a demonstration mode, showing its capabilities even if not connected to a valid engine
data stream.
There are three different demo modes:
Demo 1 has speed data simulated by the Deutz Display.
Demo 2 does not generate simulated speed data.
Demo 3 simulates various alarm conditions.
μ
ATTENTION! For normal use, the demo mode must be switched to OFF.

Restore Defaults

Allows the user to reset all configuration data to the factory defaults. The user may select either metric or imperial units. The
default values for each is shown below.
160