Jumper Settings For The Zc706 Board; Jumper Settings For The Ac701 Board - Xilinx AMS101 User Manual

Appendix B: Required Jumper Settings for Base Boards
•
See ZC702 Evaluation Board for the Zynq-7000 XC7Z020 All Programmable SoC User Guide
(UG850)

Jumper Settings for the ZC706 Board

To enable AMS evaluation, ensure the ZC706 board has the following jumper settings:
•
•
•
•
•
•
See Zynq-7000 All Programmable SoC ZC706 Evaluation Kit Getting Started Guide (ISE Design
Suite and Vivado Design Suite) (UG961)

Jumper Settings for the AC701 Board

To enable AMS evaluation, ensure the AC701 board has the following jumper settings:
•
•
•
•
•
•
•
See AC701 Evaluation Board for the Artix-7 FPGA User Guide (UG952)
52
J70: In place between pins 2 and 3
[Ref 9].
J12: Not in place (XADC GND Bypass)
J13: In place (XADC GND)
J14: In place (XADC VCC5V0)
J52: In place between pins 1 and 2 (XADC VREP Sel)
J53: In place between pins 2 and 3 (XADC VCC Sel)
J54: In place between pins 2 and 3
J11: In place
J53: In place
J9: In place
J10: In place
J43: In place between pins 2 and 3
J54: In place between pins 2 and 3
J42: In place between pins 1 and 2
www.xilinx.com
[Ref 10].
AMS101 Evaluation Card User Guide
UG886 (v1.3) November 6, 2013
[Ref 11].