Xilinx AMS101 User Manual page 14

Chapter 2: AMS101 Evaluation Card Quick Start
X-Ref Target - Figure 2-3
AMS101 Evaluation Card
USB Cable
Standard-A Plug
to Mini-B Plug
Host
Computer
4.
5.
X-Ref Target - Figure 2-4
14
To J17
(UART)
To JTAG
USB Cable
Standard-A Plug
to Micro-B pPug
Figure 2-3: FPGA Base Board Connectivity
Configure the FPGA base board jumper settings as listed in
Jumper Settings for Base
Connect the AMS101 evaluation card to the XADC header on the base board.
The AMS101 evaluation card connects to the FPGA base board by plugging the card
into the XADC header on the base board. The AMS101 evaluation card connector and
XADC header socket are keyed to align properly. Pin 1 on the XADC header needs to
connect to pin 1 of the 20-pin connector on the AMS101 evaluation card.
shows this connection.
XADC Header
Figure 2-4: AMS101 Evaluation Card Installed on the Base Board XADC Header
www.xilinx.com
Boards.
Board Power
Switch SW12
To J18
Power Supply
100 VAC–240 VAC Input
12 VDC 5.0A Output
UG886_c2_03_091012
Appendix B, Required
Figure 2-4
AMS101 Evaluation Card
Installed on XADC Header
UG886_c2_04_101812
AMS101 Evaluation Card User Guide
UG886 (v1.3) November 6, 2013