Chapter 4: Ams Evaluator Tool - Xilinx AMS101 User Manual

AMS Evaluator Tool
The AMS Evaluator tool GUI uses the National Instruments LabVIEW environment. The
GUI can be used to:
•
•
•
•
•
•
•
•
The AMS Evaluator tool allows selection of various measurements by choosing various
tabs across the top of the GUI as shown in
signal source is controlled by the panels on the right side of the tool.
X-Ref Target - Figure 4-1
AMS101 Evaluation Card User Guide
UG886 (v1.3) November 6, 2013
Configure the XADC.
Configure the signal source on the AMS101 evaluation card.
Initiate an XADC data capture.
Perform frequency and time domain analysis on XADC data.
Perform a linearity test and display the results.
Monitor the internal supply voltage and temperature sensors.
Export measurement results to a CSV file.
Leverage the FPGA to improve the performance of the XADC using Xilinx Analog
Mixed Signal (AMS) technology.
Tabs to View XADC Data
Figure 4-1: AMS Evaluator Tool GUI on Start-Up
www.xilinx.com
Figure 4-1. The configuration of the XADC and
Chapter 4
Signal Source
Generation
Decimation
via AMS
XADC Control
UG886_c4_01_110413
37