Xilinx AMS101 User Manual page 15

Ensure that all the jumper settings are correct on the AMS101 evaluation card.
shows an example of jumpers J3 and J5 (DACs enabled).
jumpers.
Note:
board.
X-Ref Target - Figure 2-5
Table 2-1: AMS101 Evaluation Card Jumper Configuration Notes
Reference Component
Callout
Designator Description
1 J2
2 J3
3 Connector
4 J5
5 J6
6
7 Amplifier
AMS101 Evaluation Card User Guide
UG886 (v1.3) November 6, 2013
Figure 2-5
The image in
7
Figure 2-5: AMS101 Evaluation Card Jumper Configuration
Jumper External signal source to V
Jumper 1–2 selects DAC signal source.
2–3 selects external input source on J2.
20-pin connector to XADC header on FPGA base board.
Jumper 1–2 selects DAC signal source.
2–3 selects external input source on J6.
Jumper External signal source to V
DAC 16-bit DAC sets analog test voltage.
Reference buffer for DAC.
www.xilinx.com
is for reference only and might not reflect the current revision of the
1
6
5
Notes
positive analog input.
P
negative analog input.
N
Quick Start
Figure 2-5
Table 2-1 explains additional
2
2
4
UG886_c2_05_092612
Schematics
Figure A-2, page 49
Figure A-2, page 49
Figure A-2, page 49
Figure A-2, page 49
Figure A-2, page 49
Figure A-1, page 48
Figure A-1, page 48
3
15