Xilinx AMS101 User Manual page 16

Chapter 2: AMS101 Evaluation Card Quick Start
6.
X-Ref Target - Figure 2-6
7.
16
Power up the FPGA base board.
The power switch can now be put in the ON position (switch toward the power plug).
Figure 2-6 shows the location of the power switch. It also shows the LEDs illuminated
on the FPGA base board. This should occur directly after the FPGA base board switch
is flipped into the ON position. A few seconds after power-up, the DONE LED should
illuminate. At this stage, hardware connection is complete.
Power Switch
Figure 2-6: Turning On the FPGA Base Board Power
Download the design to the FPGA. See the individual kit (AC701, ZC702, KC705, or
VC707) Getting Started Guides or the 7 Series FPGA AMS Targeted Reference Design User
Guide (UG960) [Ref 1], for more specific instructions on downloading the design.
For the AMS101 evaluation card to function, the FPGA needs to be programmed with
the appropriate design. To do this, download the design to the FPGA:
a. Open the Vivado ® Design Suite. Here is one example path for Vivado tools:
Start menu/Xilinx Design Tools/Vivado 2013.3/Vivado 2013.3
b. Create a Vivado Project.
c. Open a Hardware Session.
d. Open a new Hardware Target and run through the wizard.
e. Open AMS_KC705_bitstream.bit from the
rdf0280-ams101-kc705-trd-2013-3.zip file.
www.xilinx.com
UG886_c2_06_071012
AMS101 Evaluation Card User Guide
UG886 (v1.3) November 6, 2013