Xilinx AMS101 User Manual page 18

Chapter 2: AMS101 Evaluation Card Quick Start
X-Ref Target - Figure 2-9
9.
18
Select COM Port Here
Figure 2-9: AMS Evaluator Tool on Start-Up
Connect to the UART port as detailed in the appropriate FPGA/processor base board
Getting Started Guide:
• Kintex-7 FPGA KC705 Evaluation Kit Getting Started Guide (UG883)
• Getting Started with the Virtex-7 FPGA VC707 Evaluation Kit (UG848)
• Zynq-7000 All Programmable SoC: ZC702 Evaluation Kit and Video and Imaging Kit
Getting Started Guide (UG926)
• Artix-7 FPGA AC701 Evaluation Kit Getting Started Guide (UG967)
Set the USB-UART connection to a known port in the Device Manager as follows:
• Right-click My Computer and select Properties.
• Select the Hardware tab. Click the Device Manager button.
• Find and right-click the Silicon Labs device in the list. Then select Properties.
• Click the Port Settings tab and the Advanced... button.
• Select the COM port that corresponds to Silicon Labs CP210x USB to
UART Bridge (see Figure
www.xilinx.com
[Ref 4]
2-10).
AMS101 Evaluation Card User Guide
UG886_c2_09_092512
[Ref 2]
[Ref 3]
[Ref 5]
UG886 (v1.3) November 6, 2013