Xilinx AMS101 User Manual page 35

Jumpers J3 and J5 should both be set between positions 2-3 to disconnect the DAC outputs
and enable the external signal connections at J2 and J6 (pins 1 for both J2 and J6). See
Figure
X-Ref Target - Figure 3-8
Jumper J2
Jumper J6
Figure 3-8: Use Case 3 Jumper Configurations: Differential External Analog Source
AMS101 Evaluation Card User Guide
UG886 (v1.3) November 6, 2013
3-8.
Triangle Near Jumpers Indicates Pin 1
Black Filled Boxes Indicate Jumper Position
2
Ground
Apply Positive Analog
Input Signal to Pin 1
2
Ground
Apply Negative Analog
Input Signal to Pin 1
www.xilinx.com
3
1
2
1
3
1
2
1
Board Setup
Jumper J3
Jumper J5
UG886_c3_08_081612
35