Strip Position Fine Adjustmentpeel Adjust - TOSHIBA TEC Corporation B-FP Series Manual

7.5.6
Max. Min. value
value
+3.0 -2.0
Default value: 0.0mm
+0.0 mm
+3.0 mm
-2.0 mm
Paper feed direction
1 mm
<Supplemental Explanations>
・
The printer is controlled by the total amount determined by this command and the Position Fine
Adjustment command sent from the PC (strip position fine adjustment value).
maximum value is –2.0 mm to +3.0 mm.
・
This setting is not effective for B-FP3D-GS30/40 (set 0.0mm automatically).
Support mode (o：valid、x：invalid）
TPCL, TPCL1,
LABEL
o

Strip Position Fine AdjustmentPeel Adjust

Step Display
0.1 Decimal
Regardless of gap length, the stop position in strip issue mode is designed
in a manner so that printing stops when the distance from the top edge of
the strip shaft to the trailing edge of the label is 1 mm, if print position fine
adjustment value is not set.
If the above-mentioned stop position is not proper, the stop position should
be adjusted using the stop position fine adjust function for the strip issue.
3 mm ~ 7 mm
C Mode
o
Sign Integer
digit
Exist 1
Strip stop position (top edge of strip shaft)
Strip stop position (top edge of strip shaft)
Strip stop position (top edge of strip shaft)
ESC/POS Z Mode
o o
-80-
Decimal 0-padding
place
1 None
Unit of
measure
mm
However, the