Operation During Battery Charge By Ac Power Supply; In Printer Power Off State; [Charge] Led; Off - TOSHIBA TEC Corporation B-FP Series Manual

10

Operation during battery charge by AC power supply

This chapter describes the printer operations when the battery is charged through the AC adapter.

10.1 In Printer Power Off State

(1) When the AC adapter is being connected with the battery installed:
LCD
No display (Same as power off)
LED
[STATUS] LED (Green)
[CHARGE] LED (Orange)

If a USB cable is connected to the printer and the printer power is turned on under the above condition, the USB
interface may not work.
(This symptom occurs only when the USB cable is connected to the printer anytime between a connection of
the AC adapter in the printer power off state and a power on under the above condition.) This problem can
be solved by turning off the printer after disconnection of the AC adapter or removing and inserting the battery
again.
 In charging, it doesn't display battery percentage.
* Sometimes it doesn't display 100 % at full charge because of battery deterioration or environment.
...................................

OFF

Charging ..................... ON
Full charge ................. OFF
-115-