User System Mode; Outline Of System Mode For Users - TOSHIBA TEC Corporation B-FP Series Manual

9 USER SYSTEM MODE

9.1

OUTLINE OF SYSTEM MODE FOR USERS

The printer enters the system mode for users when the following operation is performed when the printer power is
off.
・
Turn on the printer while holding down the [FEED] and [POWER] keys at the same time.
The system mode is intended for performing self-test, parameter setting, and other settings.
When the top menu is displayed, the firmware version is shown on the right side of the title.
The language displayed on the panel is English when other language is selected.
The key operations for the system mode are described below.
Key operations follow Section 6.1 LIST BOX WITH SCROLLBAR.
System Mode for users top image
Top menu
1.Reset
2.Mode Setting
3.Set PARAM
4.Adjust Set
5.Dump Mode
6.Expand Mode
7.I/F SETTING
8.BASIC Setup
1.Reset
2.Mode Setting
3.Set PARAM
4.Adjust Set
5.Dump Mode
6.Expand Mode
7.I/F SETTING
8.BASIC Setup
Used to reset the printer.
Same as 7.3 Mode Setting of the system mode.
Same as 7.4 Set PARAM of the system mode.
Same as 7.5 Adjust Set of the system mode.
Used to print the data sent from the host
The printer switches the mode to execute the BASIC program.
Same as 7.9 Interface setting of the system mode.
Used to set the function of the BASIC program when it is loaded
printer.
-112-