Cmd Setting; Head Division Setting (Head Div); Head Output Division Command Parameter Setting (Head Div Cmd) - TOSHIBA TEC Corporation B-FP Series Manual

7.3.1
This setting selects print mode.

TPCL

TPCL1

LABEL

C Mode

ESC/POS

Z Mode
Default value: TPCL
*Support mode (o：valid、x：invalid）
TPCL, TPCL1,
LABEL
o
7.3.2
When a printing ratio per line is high, the value of this setting is changed to prevent print tone from becoming lighter.

AUTO

AUTO1

AUTO2
Default value: AUTO1 (none, 2 division, 3 division or 4 division)
<Commentary>
If it uses normal battery, available conditions of AUTO2 is:
- Ambient temperature is over 10 degree.
- Battery level is over 4.
- Label pitch is less than 63mm.
And the movement is: after every 10 continuous prints, it stops 3 sec.
*Support mode (o：valid、x：invalid）
TPCL, TPCL1,
LABEL
o
7.3.3
This setting enables or disables the head output division parameter of AY command.

OFF

ON
Default value: ON (Head output division parameter of AY command is enabled).
*Support mode (o：valid、x：invalid）
TPCL, TPCL1,
LABEL
o

CMD Setting

C Mode
o

Head Division Setting (HEAD DIV)

Automatic selection from 2, 3, or 4 division
Automatic selection from none, 2 ,3, or 4 division (Print quality oriented)
Automatic selection from none, 2 or 3 division (Print speed oriented)
C Mode
o

Head Output Division Command Parameter Setting (Head DIV CMD)

Head output division parameter of AY command is disabled.
Head output division parameter of AY command is enabled.
C Mode
x
ESC/POS Z Mode
o o
ESC/POS Z Mode
o o
ESC/POS Z Mode
x x
-58-