Linerless Setting (Linerless); Print Type Setting (Print Type) - TOSHIBA TEC Corporation B-FP Series Manual

7.3.4
This setting is for using a linerless label.

OFF

ON
Default value: OFF (Linerless setting is disabled.)
<Commentary>
 When linerless setting is enabled, the printer operates with the AUTO setting although AUTO1 is selected in
head division setting.
 When linerless setting is changed from OFF (disabled) to ON (enabled), back feed restriction is automatically
turned OFF (back feed not restricted).
When linerless setting enable/disable setting is changed from ON (enabled) to OFF (disabled), back feed
restriction is automatically turned ON (back feed restricted).
 When linerless setting is enabled, whether or not to perform a back feed is determined depending on back feed
restriction setting regardless of sensor setting.
*Support mode (o：valid、x：invalid）
TPCL, TPCL1,
LABEL
o
7.3.5
・
AUTO
・
BATCH
・
STRIP
Default value: AUTO (automatic selection from BATCH or STRIP)
Notes: About B-FP3D-GS30/40, this setting doesn't reflect (always BATCH).
*Support mode (o：valid、x：invalid）
TPCL, TPCL1,
LABEL
o

Linerless Setting (LINERLESS)

Linerless setting is disabled.
Linerless setting is enabled.
C Mode
o

Print Type Setting (Print Type)

Print depending on the sensor used
(Automatic selection from Batch or STRIP)
Fixed to batch issue
Fixed to strip issue
C Mode
o
ESC/POS Z Mode
o o
ESC/POS Z Mode
o x
-59-