Euro Font Code Setting (Euro Code); Maxicode Specification Setting (Maxicode Spec) - TOSHIBA TEC Corporation B-FP Series Manual

(2) Manual Selection ({.|.})
The control code of the command is {(7BH),|(7CH),}(7DH), and the control code selection is not performed.
Data of 00H to 1FH is ignored and discarded of in this mode. However, data of 00H to 1FH becomes valid
while processing the Graphic command or Writable Character command in hexadecimal mode.
{.|.} cannot be used in the data of the Data command or Display command.
(3) Manual Selection (ESC.LF.NUL)
The control code of the command is [ESC](1BH),[LF](0AH),[NUL](00H), and the control code selection is not
performed.
Support mode (o：valid、x：invalid）
TPCL, TPCL1,
LABEL
o
7.4.6
This setting determines to which code the EURO font code is to be assigned.
Max. Min. value
value
0xFF 0x20
Default value: B0
Support mode (o：valid、x：invalid）
TPCL, TPCL1,
LABEL
o
7.4.7
This setting selects a MaxiCode specification.
・
TYPE1
・
TYPE2
Default value: TYPE1
<Supplemental Explanations>
The mode specified by the command in accordance with the status of this parameter is different from the actual
mode. Also, the data transmission method differs partly. For details, refer to the B-FP Series External
Equipment Interface Specification(JEA-03580).
Support mode (o：valid、x：invalid）
TPCL, TPCL1,
LABEL
o
C Mode
x

EURO Font Code Setting (EURO Code)

Step Display
1 Hex decimal
C Mode
x

MaxiCode Specification Setting (Maxicode Spec)

Compatible with the current version
Special specification
C Mode
o
ESC/POS
x
Sign Integer Decimal
digit place
None 2
ESC/POS
x
ESC/POS
o
-67-
Z Mode
x
0-padding Unit of
measure
0 None
Z Mode
x
Z Mode
o
h