Feed Amount Fine Adjustment (Feed Adj.) - TOSHIBA TEC Corporation B-FP Series Manual

7.5.1
This setting sets a feed amount so that the label is shifted forward or backward from the print start position which
has been automatically determined.
Max. Min.
value value
+50.0 -50.0
Default value: 0.0mm
<Supplemental Explanations>
(1) The printer is controlled by the total amount determined by this command and the Position Fine Adjustment
command sent from the PC. However, the maximum value is ±50.0 mm.
(2) When the feed amount fine adjustment value for the positive (+) direction is set to more than +14.0 mm (the
distance between the print head and the sensor is –2 mm), the actual print position is corrected by +14.0 mm.
Support mode (o：valid、x：invalid）
TPCL, TPCL1,
LABEL
o

Feed Amount Fine Adjustment (FEED ADJ.)

Step Display
0.1 Decimal Exist
+0.0 mm
+3.0 mm
-3.0 mm
Paper feed direction
C Mode
o
Sign Integer
digit
2
ESC/POS
o
-76-
Decimal 0-padding
place
1 None
One label
Print start
position
Print start One label
position
One label
Print start position
Z Mode
o
Unit of
measure
mm