Back Feed Restriction Setting (Backfeed Limit); Strip Issue Back Feed Setting (Peel Backfeed) - TOSHIBA TEC Corporation B-FP Series Manual

7.3.7
・
OFF
・
ON
Default value: ON (Back feed restricted)
<Commentary>
 During label issue with sensor type specified (transmissive/reflective sensor) under the following conditions, this
setting determines whether or not to perform a back feed.
 During label issue without sensor type specified, whether or not to perform a back feed is determined according
this setting.
 When a feed is performed by using the [FEED] key or the Feed command, no back feed is performed.
However, when the label pitch is less than a distance between the head and the sensor (14.0 mm), a back feed
is performed regardless of this setting.
<Notes>
- If the setting is OFF, it stops at cut position in case 7.3.6
is HEAD.
*Support mode (o：valid、x：invalid）
TPCL, TPCL1,
LABEL
o
7.3.8
When strip position fine adjustment is set to – (negative) by using a command or in system mode, the strip position is
finely adjusted and the printing is misaligned simultaneously. This setting is used to perform a back feed and thus correct
the print position for the purpose of printing on the normal position.
・
OFF
・
ON
Default value: OFF (No back feed performed)
<Commentary>
 When the gap length is 5 mm or more, printing is not misaligned on the label, although the strip position fine
adjustment is set to - (negative). Therefore, no back feed is performed when ON (back feed performed) is
selected in this setting.
(*1)About B-FP3D-GS30/40, this setting doesn't reflect (always OFF).
*Support mode (o：valid、x：invalid）
TPCL, TPCL1,
LABEL
o

Back Feed Restriction Setting (Backfeed Limit)

Back feed restricted (Performs no back feed.)
Back feed not restricted (Performs a back feed.)
C Mode
o

Strip Issue Back Feed Setting (Peel Backfeed)

Performs no back feed.
Performs a back feed.
C Mode
o
Post-print Stop Position Setting (Stop Position)
ESC/POS Z Mode
o o
ESC/POS Z Mode
o o
-61-