Sync Window
Max. setting of the synchronisation of the rated
frequency
Inverter voltage range
Notes:
1. The factory setting is 400 V for input voltages of 3x380/400/415 V. Authorised personnel can set it to 380 or 415 V.
the factory setting is 220 V for input voltages of 3x208/220 V. Authorised personnel can set it to 208 V.
2. Factory setting is 50 Hz. Authorised personnel can set it to 60 Hz
3. IEC62040-3 [1.4.58] 3:1 crest ratio
4. IEC62040-3 including 0.. 100.. 0% transient load, the recovery time is half-cycle in order to have 5% of the stable output voltage.
Table 19. Inverter characteristics.
10.4.4. Electrical characteristics (Bypass input).
Information
Rated voltage
Voltage range
Type
Overload
Transfer time
Manual bypass type
Rated current of neutral line
Frequency
Sync Window
Notes:
The factory setting is 400 V for input voltages of 3x380/400/415 V. Authorised personnel can set it to 380 or 415 V.
the factory setting is 220 V for input voltages of 3x208/220 V. Authorised personnel can set it to 208 V.
Authorised personnel can select 50 or 60 Hz. If the UPS is selected as a frequency inverter, then the bypass status will not be available.
Table 20. Bypass input characteristics.
10.4.5. Communications.
Information
Ports
Protocol
Smart slot
Display
Table 21. Available communications.
10.5. EFFICIENCY.
Normal double-conversion mode
Eco-mode
Battery discharge mode
Battery module
Maximum air exchange
Table 22. Efficiency characteristics.
54
Information
Units
V AC
%
%
ms.
A
Hz
Hz
Units
-
Rated frequency ± 2 Hz (selectable from: ±1.. ±5 Hz)
Hz/s
% V AC
3x208/220/380/3x400/3x415
< 110 permanently / < 150 during 1 min.
Rated frequency ±2 (selectable from ±0.5.. ±5 Hz)
Parameters
RS 232 / RS 485 / Relays
MODBUS RTU
1 x SNMP / 1 x IS
7" touch screen, LEDs and keypad
Details
%
%
(Rated voltage of batteries 480 V and full linear load)
%
m
/min
4.5 / power module, 3.02 / bypass module
3
Parameters
1: selectable: 0.1.. 5
± 5
Parameters
- 40 ÷ + 25
Static thyristor
0
Uninterrupted
1.7 × In
50/60
95
98
94.5
SALICRU
Need help?
Do you have a question about the SLC ADAPT2 Series and is the answer not in the manual?