Canon imagePRESS C800 Series Troubleshooting Manual page 75

Chapter 1
B-2) Pull out the right side of the cassette [A] with the front side lifted with hands, and detach the cassette [1] by moving it to the right.
F-1-3
B-3) Loosen the 3 adjustment screws [1] at the rear side of the cassette. Using the scale [2] and the boss line [3] as reference, move the position of the pull-in guide
[4] for 1 division of the scale.
- In the case of a semi-closed cassette: Move the pull-in guide [4] for 1 division of the scale upward (toward the rear side [A] of the host machine) so that the amount
the cassette if pulled in is reduced.
- In the case of latch not locking: Move the pull-in guide [4] for 1 division of the scale down ward (toward the front side [B] of the host machine) so that the amount
the cassette is pulled in is increased.
B-4) Perform the work in the step B-2) and B-1) in reverse order to reinstall the cassette.
B-5) Check that the symptom does not occur.
In case the symptom does not improve, readjust the adjusting position in the step B-3) until the symptom no longer occurs.
B-6) Check if the gap between the cover at the rear side is within 2 to 4mm.
If the gap is other than the range of 2 to 4mm, perform the work in the work A) to adjust the cassette front cover.
1-61