Misalignment after cassette side registration adjustment between the cassette front cover and the position to which the pull-in guide should be adjusted causes the
above symptom.
Service work
Preparatorily, measure the gap [B] between the cover on the rear side [2].
In case of semi-closed, push the cassette [1] further first and then measure the gap [B] between the cover on the rear side [2].
To semi-closed, perform the work A). If the symptom does not improve, perform the work B) subsequently.
To latch not locking, perform the work B).
A) Adjusting the cassette front cover
A-1) Pull out the cassette [1], loosen the 2 adjustment screws [2] on the left side, and adjust the cassette front cover [4] using the 2 scales [3] as reference until the
gap [B] from the cover on the rear side that was measured preparatorily changes to a value between 3 and 4 mm.
A-2) Check that the symptom does not occur. If the symptom no longer occurs, the work is completed.
If the symptom does not improve, go to the work B).
B) Adjusting the pull-in guide
B-1) Pull the cassette and let the cassette come out until it touches to the stopper [2] as loosening the screw [1].