[Note] In case adjust Paper Realignment Speed will not be displayed on the control panel, change the setting value of Service Mode > Mode List > COPIER >

Option > DSPLY-SW > IMGC-ADJ to "1" and perform a power-cycle of main power (off/on). The value is "0" by default.

6) If the adjust Paper Realignment Speed screen is displayed, the presetting is completed.

7) Select the adjust Paper Realignment Speed screen, press "-" button three times and if the corrected value[a] is confirmed to be "-0.3", then press "OK".

The range of setting is from "-3.0" to "+3.0" ("0" by default). Changing this value changes the Paper Realignment Speed.

1-15

Table of Contents