Certification; Ce-Marking; Ul Marking - KEB COMBIVERT H6 Series Instructions For Use Manual

cERTIfIcATION

6 Certification

6.1 cE-Marking

CE marked drive converters and servo drives were developed and manufactured to
comply with the regulations of the Low-Voltage Directive and EMC Directive.
The COMBIVERT meets the requirements of the Low-Voltage Directive. The harmo-
nized standards of the series
The COMBIVERT is a product of limited availability in accordance with
product may cause radio interferences in residential areas. In this case the operator may
need to take corresponding measures.
The machine directive, EMC directive, Low Voltage Directive and other guidelines and
regulations must be observed depending on the version.

6.2 UL Marking

Acceptance according to UL is marked at KEB inverters with the adjacent logo on
the type plate.
To be conform according to UL for use on the North American and Canadian Market the
following additionally instructions must be observed (summary of original texts of the
UL-Files):
•
•
•
•
•
•
•
•
•
EN 61800-5-1
These devices shall be mounted within a suitable ultimate enclosure.
These devices are intended for use in a controlled environment, Pollution Degree 2
or cleaner.
The spacings from exposed live parts to other live parts or enclosure shall be main-
tained in accordance with the requirements for the end-use equipment.
Devices provided with Flat Rear Heat Sink are intended to be mounted with ade-
quate Heat Sink assemblies in the end-use equipment. The cooling suitability of the
devices provided with a Flat Rear Heat Sink, shall be determined in the end-use
equipment by subjected Temperature Test.
These devices shall be used within their electrical rating.
The terminals on these devices are suitable for factory and field wiring.
These devices are evaluated for use in maximum Surrounding Air Temperature of
45°C.
These devices shall be provided with a wiring diagram to indicate the wiring con-
nections.
These devices are evaluated for use with the following copper conductors only:
for drive converter were used.
EN 61800-3.This
69