Certification; Ce Marking; Ul Marking - KEB COMBIVERT H6 Series Instructions For Use Manual

CERTIFICATION

5 Certification

5.1 CE Marking

CE marked drive converters and servo drives were developed and manufactured to
comply with the regulations of the Low-Voltage Directive 2006/95/EC.
The drive converter or servo drive must not be started until it is determined that the
installation complies with the Machine directive (2006/42/EC) as well as the EMC-direc-
tive (2004/108/EC)(note
The drive converters and servo drives meet the requirements of the Low-Voltage Direc-
tive 2006/95/EC. The harmonized standards of the series
with
This is a product of limited availability in accordance with
cause radio interference in residential areas. In this case the operator may need to take
corresponding measures.

5.2 UL Marking

To be conform according to UL for use on the North American and Canadian Market the
following additionally instructions must be observed (summary of original texts of the UL
files):
•
•
•
•
•
•
•
•
•
52
EN 60204-1).
EN 60439-1 and EN 60146
Acceptance according to UL is marked at KEB inverters
with the adjacent logo on the type plate.
These devices shall be mounted within a suitable ultimate enclosure.
These devices are intended for use in a controlled environment, Pollution Degree
2 or cleaner.
The spacings from exposed live parts to other live parts or enclosure shall be main-
tained in accordance with the requirements for the end-use equipment.
Devices provided with Flat Rear Heat Sink are intended to be mounted with ade-
quate Heat Sink assemblies in the end-use equipment. The cooling suitability of
the devices provided with a Flat Rear Heat Sink, shall be determined in the end-
use equipment by subjected Temperature Test.
These devices shall be used within their electrical rating.
The terminals on these devices are suitable for factory and field wiring.
These devices are evaluated for use in maximum Surrounding Air Temperature of
45°C.
These devices shall be provided with a wiring diagram to indicate the wiring con-
nections.
These devices are evaluated for use with the following copper conductors only:
were used.
EN
EN 61800-5-1 in connection
61800-3. This product may