Pppoe: Auto Ip Address Assignment; Figure 19 Pppoe Encapsulation: Auto; Table 10 Pppoe Encapsulation: Auto - ZyXEL Communications ZyWALL 1050 User Manual

4.3.4 PPPoE: Auto IP Address Assignment

If you select Auto as the IP Address Assignment in the previous screen, the following screen
displays after you click Next.

Figure 19 PPPoE Encapsulation: Auto

The following table describes the labels in this screen.

Table 10 PPPoE Encapsulation: Auto

LABEL
ISP Parameters
Encapsulation
Service Name
User Name
Password
Retype to Confirm Type your password again for confirmation.
Nailed-Up
Idle Timeout
WAN IP Address
Assignments
Chapter 4 Wizard Setup
DESCRIPTION
This displays the type of Internet connection you are configuring.
Type the PPPoE service name given to you by your ISP. PPPoE uses a service
name to identify and reach the PPPoE server. You can use alphanumeric and -
_ @$./ characters, and it can be up to 64 characters long.
Type the user name given to you by your ISP. You can use alphanumeric and -
@$./
_ characters, and it can be up to 31 characters long.
Type the password associated with the user name above. Use up to 64 ASCII
characters except the [] and ?. This field can be blank.
Select Nailed-Up if you do not want the connection to time out.
Type the time in seconds that elapses before the router automatically disconnects
from the PPPoE server. The default time is 100 seconds.
ZyWALL 1050 User's Guide
73