Resetting The Zyair; Procedure To Use The Reset Button; Figure 2-2 Change Password Screen - ZyXEL Communications ZyAIR User Manual

ZyAIR Wireless Gateway Series User's Guide
Step 7. You should now see the MAIN MENU screen.
The ZyAIR automatically times out after five minutes of inactivity. Simply log back
2.3

Resetting the ZyAIR

If you forget your password or cannot access the ZyAIR, you will need to reload the factory-default
configuration file or use the RESET button on the side panel of the ZyAIR. Uploading this configuration file
replaces the current configuration file with the factory-default configuration file. This means that you will
lose all configurations that you had previously and the speed of the console port will be reset to the default of
9600bps with 8 data bit, no parity, one stop bit and flow control set to none. The password will be reset to
"1234", also.

2.3.1 Procedure to Use the Reset Button

Make sure the SYS LED is on (not blinking) before you begin this procedure.
Step 1. Press the RESET button for more than five seconds, and then release it. If the SYS LED begins
to blink, the defaults have been restored and the ZyAIR restarts. Otherwise, go to step 2.
Step 2. Turn the ZyAIR off.
Step 3.
While pressing the RESET button, turn the ZyAIR on.
Step 4. Continue to hold the RESET button. The SYS LED will begin to blink and flicker very quickly
after about 10 or 15 seconds. This indicates that the defaults have been restored and the ZyAIR is
now restarting.
Step 5. Release the RESET button and wait for the ZyAIR to finish restarting.
2-2

Figure 2-2 Change Password Screen

into the ZyAIR if this happens to you.
Introducing the Web Configurator