Table of Contents
Advertisement
Draco tera
Activating the automatical Scan Mode for CPU Devices
The matrix offers the ability to use a scan mode based on the favorite list
of each console or user. Scan mode allows the matrix to switch in
sequence between the CPU Devices in the favorite list within a predefined
time. All scans are performed in video only mode.
To configure scan mode, refer to Chapter 5.13.1, Page 140.
You have the following option to activate the scan mode:
In order to activate scan mode, proceed as follows:
1.
Define a favorite list for the respective CON Device or user (see
Chapter 5.13.4, Page 152 for CON Devices or see Chapter 5.5.2,
Page 110 for users)
2.
Start Command Mode with the 'Hot Key' and press <o> to open OSD.
3.
Select one of the CPU Devices in the CPU selection list that are
defined in your favorite list.
4.
Confirm your selection by pressing the CPU Scanner button. The
scan will automatically start.
5.
If you have enabled the Force CPU Scan option, the scan will
automatically start after switching the respective CON Device to any
CPU Device from the favorite list without the need to press the CPU
Scanner button.
210
2020-02-26
Advertisement
Table of Contents
