Wiring Zones - Honeywell Galaxy Dimension Series Installer Manual

Galaxy Dimension Installer Manual

Wiring Zones

The zones on Galaxy Dimension panels can be Double Balanced (default) or End of Line. Zones can be
programmed with different resistance ranges for zone status activation (see Parameter 51.46 =
Parameters.Zone Resistance). Refer to Table 2-7 (Double Balanced) or Table 2-8 (End of Line) for
details of the zone resistance and resulting conditions.The system default is Option 9, giving fault monitoring on
1k double balanced wiring.
NOTE: The circuit debounce time (the period the zone must remain in a state to register a change in condi-
tion) is 300 milliseconds by default.
Option 01 - 1k
Tamper S/C 0 - 800
Low Res 800 - 900
Normal 900 - 1200
High Res 1200 - 1300
Open 1300 - 12000
Fault -
Masked 12000 - 19000
Tamper O/C 19000 - infinity
Table 2-7. Double Balanced Zone Resistance and Conditions
Option 09 - 1k Fault Double-balanced (default)
The wiring in Figure 2-10 should be used if the detector uses combined fault and mask signalling. A mask
condition is generated if an alarm and fault are signalled at the same time. Alternatively, if the detector has
seperate fault and mask indications then the wiring in Figure 2-11 should be used.
Zone
Figure 2-10. Option 09 - Double balanced 1k Fault Monitoring Wiring
Zone
Figure 2-11. Option 09 - Double balanced 1k Fault/Mask Monitoring Wiring
NOTE: N/C = Normally Closed.
Option 03 - 2k2 Option 05 - 4k7
0 - 1800 0 - 3700
1800 - 2000 3700 - 4200
2000 - 2500 4200 - 5500
2500 - 2700 5500 - 6500
2700 - 12000 6500 - 19000
-
12000 - 15000 19000 - 22000
15000 - infinity 22000 - infinity
1k
Tamper N/C
Alarm N/C
100 m
1k
Alarm N/C Tamper N/C
2-13
Wiring Zones
Option 07 - 5K6
0 -1400
1400 - 2800
2800 - 8400
8400 - 9800
9800 - 12600
- -
12600 - 22000
22000 - infinity
3k
Fault N/C
3k
Fault N/C Anti-Mask N/C
100 m
Option 09 - 1k Fault
0 - 800
800 - 900
900 -1200
1200 - 1300
1300 - 3500
3500 - 4500
4500 - 19000
19000 - infinity
1k
12k
1k