The Galaxy Dimension Touchcenter; General; Touchcenter Installation Procedure - Honeywell Galaxy Dimension Series Installer Manual

Galaxy Dimension Installer Manual

The Galaxy Dimension TouchCenter

General

The Galaxy Dimension TouchCenter connects to the RS485 data bus of the Galaxy Dimension panels. The
TouchCenter combines a clear graphical display with simple touch-screen control, providing an easy user
interface.

TouchCenter Installation Procedure

1 Remove the mounting plate from the TouchCenter by pushing it towards the bottom of the keypad.
2 Locate the mounting plate over the mounting surface such that the opening of the mounting plate is
aligned with the cable.
3 Pass the cable through the opening of the mounting plate.
4 Secure the mounting plate to the mounting surface using the four screws supplied.
5 Connect the wires to the TouchCenter terminals as per the following table:
6. Mount the TouchCenter to the mounting plate by locating the four elongated holes over the locations on
the mounting plate and pushing down until it snaps into position.
Mk7 Keypad
Interface button
Figure 4.3 Homepage Screen
Galaxy Terminals
A
B
GND
+12V
Table 4-5. TouchCenter Terminal Connections
TouchCenter
EMERGENCY
button
TouchCenter Terminals
G
Y
-
+
4-9