Honeywell Galaxy Dimension Series Installer Manual page 172

53 - Program Outputs (cont'd)
18 E/E Horn (Latch)
The Entry/Exit Horn output has a dual function:
• in an alarm condition its function is identical to that of the Horn output;
• during the unsetting and setting of the system it is used to provide an indication on the
status of the system. The indication states are as follows:
• General Alarm
• Clear to Exit
• Exit interrupted
• 75% Exit Time
• Set
• Normal Entry
• 75% Entry Time
• Fire
• Chime
19 Part Set (Reflex)
The Part Set output is activated when the assigned groups on the system are part set. This output is a Reflex
output and follows the part set and unset status of the groups.
20 Confirm (Latch)
The Confirm output is activated when there have been activations on two separate zones: the second activa-
tion must occur within the Confirm Time Window. The zones do not have to be in the same group, however,
both groups must be assigned to the Confirm output to allow activation. Cross-group confirmation is control-
led by the Communications programming in menu 56.1, Int Telecoms or 56.5, Ext Telecoms. If signalling
is by DTMF format, cross-group confirmation will occur on groups that share the same confirm channel. In all
other signalling formats, cross-group confirmation will occur on groups that share the same account number.
NOTE: The Confirm output is used to give positive identification that a genuine intruder alarm condition has
occurred and to minimise the possibility of false alarm activations.
21 Line Fail (Reflex)
The Line Fail output is activated whenever a Line Fail zone is active or the telecom module detects and
sustains a line failure for more than 30 seconds.
22 Video (Pulse)
The Video output is activated by the Video zone when the system is set. This output can be used to activate
video recorder or video transmission systems.
23 Comm Fail (Latch)
The Comm Fail output is activated whenever there is a communication failure on the telecoms module tel-
ephone line. A fail to communicate event overrides the remaining Bell Delay period.
- ON 500 msecs. OFF 500 msecs.
- Continuous
- ON 100 msecs. OFF 100 msecs.
- ON 200 msecs. OFF 200 msecs.
- ON 600 msecs. OFF 600 msecs (twice)
- ON 800 msecs. OFF 200 msecs.
- ON 200 msecs. OFF 200 msecs.
- ON 500 msecs. OFF 100 msecs.
- ON 500 msecs. OFF 400 msecs (twice)
6-98
Galaxy Dimension Installer Manual