Max3 - Honeywell Galaxy Dimension Series Installer Manual

Galaxy Dimension Installer Manual
MAX
3
The MAX is a proximity reader access control device for a single door, which can also be used for setting
3
and unsetting of your alarm control panel. The MAX
Standalone
In this configuration the MAX
connecting the internal relay output to a door lock or external relay. When in standalone mode the MAX
programmed and operated using the MAX
unique ID numbers and must be identified to the MAX
memory can store up to 999 ID numbers, including at least three reserved for Masters. Once programmed,
the ID number of the tags and cards are stored indefinitely in the MAX
erased. Removing power from the MAX
Note : The MAX 3 defaults to standalone mode. It can be configured to on-line mode directly from the
Galaxy Dimension control panels.
On-line
The MAX can operate in on-line mode, with the Galaxy Dimension control panel range, as a completely
3
integrated module on the system. In this configuration the MAX
system set/unset control with complete user traceability stored within the Galaxy control panel.
For detailed instructions on how to programme the MAX
69.2=MAX.
Installing the MAX
MAX Pack
3
Your Max 3 pack contains the following:
• Max proximity reader *
3
• Max drilling template
3
• Max installation instructions
3
• Surge suppressor
* The MAX 3 is supplied with 3 metres of 12 wire E111235 AWG cable which is fixed and sealed through a
keyhole opening on the rear surface of the MAX
Mounting the MAX
To mount the MAX use the step by step diagrams provided with the drilling template.
3
The drilling template should be used as an aid to locate the holes required to secure the MAX
connection cable.
The MAX 3 comes with an infra red lid tamper. The tamper is activated when the lid is removed from the
MAX unit.
3
can be used for either door control or alarm system set/unset control, by either
3
proximity cards or tags.The proximity cards and tags each have
3
does not erase the programming memory.
3
3
.
3
3
Access Control (cont'd)
can be configured in one of two ways:
3
before being used to operate the system. The MAX
3
memory until voided (removed) or
3
3 can be used for both door control and alarm
3 onto the system in on-line mode refer to Option
5-7
is
3
3
3 and insert the