Honeywell Galaxy Dimension Series Installer Manual page 24

RIO Switch
Zone Addressing with Onboard RIO Switch (Line 0 Switch)
The RIO switch (SW3, dipswitch 8) controls the ordering of the on-board RIO's. This dipswitch must be set
before powering up the panel. Setting the switch to ON sets the on-board RIO1 to operate on line 0 and
allows a RIO addressed as 1 to be connected to line 1, giving a total of 15 RIO's on a GD-264 and
GD-520. The RIO switch only needs to be activated when the full compliment of RIO's is required, or when
replacing a Galaxy 512 panel with a power supply/RIO already using address 1.
NOTE: The RIO switch is not functional on other variants. It defaults to the Switch off configuration.
Switch off (default)
When the switch is set to this mode, the onboard RIO's configure to the following addresses:
Onboard RIO0
Onboard RIO1
Switch on
When the switch is set to this mode, the onboard RIO's configure to the following addresses:
Onboard RIO0
Onboard RIO1
Panel On-Board RIO Address Range
GD-48 1001 - 1008, 1011 - 1018
1001 - 1008, 1011 - 1018 (switch off)
GD-96
1001 - 1008, 0011 - 0018 (switch on)
GD-264 1001 - 1008, 1011 - 1018 (switch off)
1001 - 1008, 0011 - 0018 (switch on)
1001 - 1008, 1011 - 1018 (switch off)
GD-520
1001 - 1008, 0011 - 0018 (switch on)
Zone address range:
Zone address range:
Zone address range:
Zone address range:
Table 2-6. Zone Address Ranges
Galaxy Dimension Installer Manual
1001-1008 Outputs:
1011-1018 Outputs:
1001-1008 Outputs:
0011-0018 Outputs:
Total Max No of
on-board External RIO's
Zones (Line 1)
16 4
16 4
16 5
16 14
16 15
16 14
16 15
2-12
1001-1004
1011-1014
1011-1014
0011-0014
Valid External Total Zone
RIO Addresses Addresses
(Line 1) (Switch ON)
2 - 5 48
2 - 5
96
1 - 5
2 - 9, A - F
264
1 - 9, A - F
2 - 9, A - F
520
1 - 9, A - F