MAINTENANCE
9. Maintenance
WARNING:
An overall inspection of the OnRobot's End of Arm Tooling must be performed
regularly and at least once every 6 months. This inspection must include but is
not limited to check for defective material and clean gripping surfaces.
Use original spare parts, and original service instructions for the OnRobot's End
of Arm Tooling and the robot. Failure to comply with this precaution can cause
unexpected risks, resulting in severe injury.
If you have questions regarding spare parts and repair, please visit our website
www.onrobot.com
9.1. RG2-FT
WARNING:
Please clean the proximity sensor surface regularly with low pressure
compressed air (<5 bar) from a 5 cm distance. For stronger contamination use
isopropyl alcohol with a soft cotton swab to keep it clean.
to contact us.
79
Need help?
Do you have a question about the UR CB3 Series and is the answer not in the manual?