Table of Contents
Advertisement
HW INSTALLATION
Finally, power up the power supply that will power the Compute Box and the connected
Tool(s).
4.4.3.1. RG2-FT
Tool
Power Supply 1.5 A Power Supply 5 A Power Supply 6.25 A
RG2-FT
16
NOTE:
To disconnect the power connector,
make sure to pull the connector housing
(where the arrows are shown) and not
the cable.
CAUTION:
Use only original OnRobot power
supplies.
Advertisement
Table of Contents
Need help?
Do you have a question about the UR CB3 Series and is the answer not in the manual?
Questions and answers