Operation; Urcap Commands; Rg2-Ft; Rg Grip - OnRobot UR CB3 Series User Manual

OPERATION

6. Operation
NOTE:
It is assumed that the Installation has finished successfully. If not, first do the
installation steps in the previous section.

6.1. URCap Commands

URCap commands provide an easy way to program an application.

6.1.1. RG2-FT

NOTE:
At program start the force/torque finger sensors are automatically zeroed so
no need to place a HEX-Zero command at the beginning of the program.
Please make sure that the fingers are not in contact with any obstacle when
the program is started. Otherwise the sensors will not be properly zeroed.

6.1.1.1. RG Grip

When the
RG Grip
(Width) and F (Force)) and, if selected, Depth compensation ON and/or Automatic centering
ON. The different functions are explained below.
NOTE:
To cancel any force/torque offset, execute an
beginning of the
contact with any object before starting the program, otherwise the command
may not work properly.
28
command is executed, the gripper will try to reach the specified target (W
command and make sure the gripper is not in
RG Grip
command at the
HEX-Zero